[HungryBear]

Hitting Alignment. Loading the Primary Lever vs Loading the Secondary Lever.

Vary the Loading Action by Varying the Right Elbow Alignment. See Magic of the Right Forearm. At the End of Start-up, choose either to Pitch the Elbow (Standard Wrist Action) to load the Secondary Lever (Shaft), or raise the Elbow (Single Wrist Action) to Load the Primary Lever (Left Arm and Shaft).

Note that regardless of Loading action or Swinging or Hitting, the Impact Alignments are identical. The Flying Wedges are aligned at Right Angles, the Left Wrist is Flat and Level, the Right Wrist is Bent and Level, the Right Forearm is On-Plane, etc.

Note also, that because the Primary Lever is "Loaded", it cannot Swing (Throwout) although it will and should be pulled. If you make the mistake of trying to swing the Left Arm, the #3 PP will "Un-Load".

Swinging is Harnessing CF. Hitting is Overpowering CF. It's still there, it's no longer a factor.

Great info post on hitting , gets to the point doesn"t it?

I have been thinking about releases and started to wonder on a couple of things. I can swing, with either hand or both. That is a swinging procedure. BUT I can not hit with either hand by itself. The left must be there to checkrein the thrusting right hand. and complete a primary lever assembly. There are 2 pressure points in operation at the same time- #1 thrusting the primary lever assembly and an ACTIVE #3 which also keeps the secondary assembly "moving right along" There are all manner of options. For any stroke length, the #1 thrust can be increased or decreased- #3 pressure should follow. For any #1 thrust, the stroke length can be adjusted. #3 should follow and be constant. But, there can be an background amount of cf and it can come from a pulling, can be generated from the pivot and is realy #4 accumulator. It is background and care must be taken not to damage the work of either #1 thrust or #3 activity.

Like to hear your thoughts on this Daryl

HB